Skip to Content
Specialist in high-end audio
Independent, tailored advice
Carefully shipped

IsoTek V5 Elektra 6-way (2/4) mains filter

The IsoTek V5 Elektra is the entry-level model among IsoTek's power cleaning systems, with six independent outputs and six separate cleaning networks. Four outputs (5 A) are for source components and two high-current outputs (10 A) for amplifiers; RFI reduction 55 dB, 450 x 106 x 350 mm.

About the IsoTek V5 Elektra

The V5 Elektra is IsoTek's new entry-level power-cleaning system for components, with six independent outlets and six separate cleaning networks. The Elektra is 450 mm wide, 350 mm deep and 106 mm high. It has two high-current outlets (for amplifiers) driven by a two-stage high-current cleaning network consisting of both a choke and a double Pi filter design. Each of the four remaining medium-current outlets (for your source components) has four independent six-stage delta filters. These give almost 20 dB of power cleaning at 1 kHz (600 Ohm reference), rising to almost 40 dB at 10 kHz, ten times more than the recommended standard. A further five independent filter stages are placed between each outlet, combined with IsoTek's Adaptive Gating system, which is twice as effective as that of the EVO3 Aquarius. This is designed to prevent differential-mode cross-contamination between the different outlets.

So in effect, Elektra is six power-cleaning systems in one housing. Most power filters of this type connect the outlets to each other in series. This is an error of judgement, because differential-mode noise caused by the connected load (your audio components) contaminates the outlets mutually. The electrical architecture with multiple power-cleaning networks, one for each outlet of the V5 Elektra, prevents this and is therefore unrivalled.

Both differential- and common-mode noise are drastically reduced. Cross-contamination of connected components is also kept to a minimum thanks to multiple multi-stage cleaning networks: one for each outlet. Most mains filters connect the outlets to each other in series. This is a mistake, because the differential-mode noise caused by the connected electronics will cause cross-contamination from one outlet to another.

The electrical architecture and design of the V5 Elektra meet IsoTek's high standards of purposeful design. The design and topology of the circuit board (PCB) contain twice as much copper as the industry standard and are silver-plated to increase current capacity and reduce resistance. Unique critical (custom-made) components have better overall tolerances with improved inductance and current handling compared with the EVO3 series. This new circuit offers twice the inductance and 40% more current compared with the EVO3 Aquarius. This leads to a more open and spacious sound, micro-dynamics and more detail with more immediate timing. The DCR (Direct Current Resistance) has also been considerably improved in this new design. One of IsoTek's aims is to lower the DCR, bringing performance closer to the zero-Ohm ideal.

Thanks to these technological improvements, the V5 Elektra delivers an absolute power of 10A and unrestricted current delivery (almost 16A transient), insofar as this is permitted within a product designed for 10A under the standards of the electricity company and laws and regulations.

KERP © (Kirchhoff's Equal Resistance Path) guarantees equal resistance and equal current delivery for all outlets. The internal wiring is of the highest quality and consists of a unique 2 mm2 design with pure 6N oxygen-free copper conductors, each individually silver-plated. This gives them low resistance and high current capacity. A fluorinated ethylene propylene (FEP) dielectric with very low dielectric losses is used to protect the conductors and provide ideal conductor contact for the internal power delivery system.

In addition, the surge protection of the V5 Elektra has been increased to 67,500A, protecting not only the circuit but also your valuable connected equipment by means of IsoTek's unique sequential and repeatable protection system. The V5 Elektra also includes a System Link outlet, designed to connect several units to each other while maintaining a star ground reference, so multiple wall sockets are not needed.

The internal wiring of IsoTek products works together with IsoTek's power cables. A critical but overlooked area in audio is maintaining commonality of design and material properties through an audio wiring loom, whether it is a signal-carrying cable or a power cable network.

IsoTek's award-winning EVO3 Initium power cable is also included.

Features
  • Suitable for all audio or AV systems
  • RFI reduction of 55dB
  • 6 optimised power-cleaning circuits to eliminate common- and differential-mode noise from the wall socket
  • 4 independent outlets for source components (5A)
  • 2 independent high-current outlets for power amplifiers, active subwoofers, active loudspeakers etc. (10A)
  • Easy-to-replace fuse
  • 67,500A surge protection, 32,500A continuous
  • Fully star-grounded network
  • 6N oxygen-free silver-plated copper conductors with FEP dielectric
  • SYSTEM LINK outlet for extending outlets while maintaining a star-grounded reference
  • Supplied with IsoTek EVO3 INITIUM POWER CABLE
  • UK, EU, US, AU & CH connections available

IsoTek V5 Elektra specifications

NUMBER OF OUTLETS
6 + System Link
OUTLET TYPE
UK, EU, US, AU & CH
MAINS INPUT
10A IEC C14
MAINS SUPPLY
100-240V / 50-60Hz
MEDIUM CURRENT - 230V
x4 (5A 1,150W total)
HIGH CURRENT - 230V
x2 (10A 2,300W total)
SYSTEM LINK
x1
SURGE PROTECTION
67.500A
DIMENSIONS (L X H X D)
450 x 106 x 350mm
WEIGHT
9.0kg
Advice or a listening session

Would you like to hear this first? In our two listening rooms on Hoenderstraat in Maastricht, each with its own acoustics, we will set up the system for you. Make an appointment or call 043-7370028 — we are happy to help you find the right choice and the right placement.

Warranty

We guarantee that this product complies with the agreement, the specifications in the offer and the statutory provisions. Many brands also give their own warranty on their equipment. An additional warranty never limits your statutory rights: you can always rely on the law. Something wrong with your purchase? Contact us. Read more about warranty

  • Brand
  • Colour
  • Upgrade cable
Price
€ 1,299.00 € 1,299.00 € 1,599.00
Price per item Including VAT
In stock
Shipping · Returns · Warranty · General terms and conditions

Matching accessories

Accessories that go with this product.

Reviews
4,5

Very good — 48 reviews on Google

Neatly packed and shipped

Very satisfied with the service of this shop. I recently ordered a Rega phono amplifier and a matching cable, and they were shipped neatly packed.

Johan T.2025

Beautiful shop in the centre of Maastricht

Great repair service. Beautiful shop in the centre of Maastricht with great equipment and friendly, enthusiastic and knowledgeable staff / owners. I was helped very well.

Raymond B.2025

The owner closed the shop to help

I bought a second-hand soundbar from Audiofrenzy. The service is quick and friendly. I needed help getting the device into my car and the owner helped me straight away — he closed the shop to do so. Old-fashioned service and respect for the customer.

Jen V.May 2026

Read all reviews on Google

Why Audiofrenzy

At Audiofrenzy we believe that music only truly comes to life with the right equipment. Our specialists are happy to help you make the best choice for your system.

Expertise

Years of knowledge of high-end audio, translated into practical advice.

Quality

Every product is carefully checked before it is delivered to you.

Personal

Questions about a product or your system? Feel free to get in touch.